⚠️ UK Access Block Notice: Beginning July 1, 2025, this site will no longer be accessible from the United Kingdom. This is a voluntary decision made by the site's administrators. We were not forced or ordered to implement this block.
I constructed and 3d-printed a simple night-night device.
Thread starterpuffinmowmow
Start date
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
lol apologies. pics not attached. gimme a sec
you can place it on the spots with the 2 balls, and slip thru anything (example with the rope of a bathrobe ahhahaa) it does not WORK YET THO.
Good luck with figuring it out. I've tried doing some blocks that the rope will sit in and press them into the side of the neck but I just couldn't get them to stay still, so a bit of a fixture like you have done is neccessary.
There is a design that has been shared on here which was following the Korean Method (whatever that is) and it had two adjustable screws that can go onto the neck and tightened independently. I wish I was clever enough to make one like that.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.